FAQ

How to determine trolling motor shaft length?

How is trolling motor shaft length measured?

The shaft length on a trolling motor is measured from the base of the motor head down the the top of the motor compartment.

How do you measure the shaft length on a Minnkota trolling motor?

Measure down from the mounting surface of the transom or bow to the water level. Add 5" to waterline measurement for fishing in rough water. Add 12" to waterline measurement for steering a hand control motor while standing. Use this measurement and the tables below to find the appropriate trolling motor shaft length.

Can trolling motor shaft be too long?

However, if the shaft is too long, the propeller creates turbulence deep beneath the boat that will spook any nearby fish. And if the shaft is too short, the prop won’t be adequately submerged, which will create noisy chop in the water and also scare away the fish.

How do you determine shaft length?

https://www.youtube.com/watch?v=gATD8c4mAsI

How does Minn Kota measure shaft length?

Measure down from the mounting surface of the transom or bow to the water level. Add 5" to waterline measurement for fishing in rough water. Add 12" to waterline measurement for steering a hand control motor while standing. Use this measurement and the tables below to find the appropriate shaft length.

How is boat shaft length measured?

But, how do you measure it? To measure your outboard motor shaft length, measure from the bottom of the mounting bracket where it rests on the transom to the top of the cavitation plate, this is the horizontal surface of the lower unit immediately above the propeller.

Can you change the shaft length on a Minn Kota trolling motor?

Yes, you can shorten the shaft of some Minn Kota trolling motors. However, Minn Kota recommends taking it to an Authorized Minn Kota Repair Center. Doing so will ensure you do not void the warranty of your trolling motor. Not all Minn Kota trolling motor shafts can be shortened, only specific models.

How deep in the water should my trolling motor be?

A Few Important Rules to Remember Submersion Rule: You’ll want the top of the motor submerged at LEAST 12" under the water to ensure adequate power and to prevent noisy cavitation which will scare fish.

How do I stop my trolling motor from bouncing?

https://www.youtube.com/watch?v=sY7V9Utty74

Can you shorten the shaft on a Minn Kota?

We recommend having the shaft shortened at an Authorized Service Center. If your motor is under warranty and you shorten the shaft yourself, it will void your warranty. If the shaft is shortened at an Authorized Service Center, it will not void your Minn Kota warranty.

What shaft length should I use?

Driver Shaft Length Based Solely on Height

Height (feet/inches)Driver Shaft Length
5’4″-5’7″45.5″
5’2″-5’4″45″
5’0″-5’2″44.5″
4’10”-5’0″44″

What happens if you put a long shaft motor on a short shaft boat?

It will will *run* fine, but it can cause bad handling. Also trim position settings will have a greater effect. No harm to try it, carefully, and see how it goes. The only other downside I can think of is a setup like that will cause you to need deeper water to run in.

Maybe you are interested in:

how to remove throttle control on boat?

Related searches

  1. minn kota shaft length measurement
  2. how deep should my trolling motor be in the water
  3. motorguide shaft length
  4. can a trolling motor shaft be too long
  5. trolling motor shaft length for deep v
  6. trolling motor shaft length for kayak
  7. minn kota trolling motor size chart
  8. trolling motor shaft length for jon boat

Related Articles

Leave a Reply

Your email address will not be published.

Check Also
Close
Back to top button